"RedNet 4", "RedNet MP8R" produced by Focusrite.Solved a problem in which the HA parameter of channel 1 of a device mounted on on the REMOTE HA ASSIGN screen would be reset to the initial value when one of the following I/O devices were mounted with the WITH RECALL parameter set to OFF on the REMOTE HA ASSIGN screen.
#N52te editor v5.01 series
However, Dante Controller will be needed to manually change the settings of R series units that are not mounted on the console with Console ID #1. This will remove the possibility data inconsistency between the console and the mounted R series units. Therefore, after updating, it is recommended to briefly change the Latency to 1.0ms on the console with the Console ID #1, then restore the original setting again. This might occur only when the Dante Latency was set to 0.25ms or 0.5ms. The Dante settings might not be properly initialized when the firmware is updated, which results in data inconsistency between the CL/QL console and the R series units.
#N52te editor v5.01 windows
Please use Windows 7, Windows 8.1, or Windows 10.
#N52te editor v5.01 update
The Dante Firmware Update Manager since v1.4.16.6 for Windows does not support Windows XP.You need to update the Dante-MY16-AUD firmware to V3.3.9 or later before using the Dante-MY16-AUD with the CL series.It is also known as Green Ethernet and IEEE802.3az. * EEE (Energy Efficient Ethernet) is a technology that reduces switch power consumption during periods of low network traffic. If you use unmanaged switches, make sure to not use network switches that support EEE.Make sure that EEE is disabled on all ports used for real-time Dante traffic. If you use managed switches, ensure that they allow EEE to be disabled.This may cause EEE to be enabled in Dante networks when it is not appropriate, resulting in poor synchronization performance and occasional dropouts. Please do not use the EEE function (*) of network switches in a Dante network.Īlthough power management should be negotiated automatically in switches that support EEE, some switches do not perform the negotiation properly. Updating Dante firmware by using a USB flash drive takes approximately 30 minutes. Prior to V3.0, the CL and QL Series used different files when updating, but both files used the same name * "C-MD1.BIN." For this reason, an error may occur during update when the incorrect "C-MD1.BIN" file is used or left in the root directory. BIN if any exists in the root directory of the USB memory. This method allows you to update both the Dante firmware and the "CL_SUBP_V500.BIN" and "MCLP5_01.PGM" files together at the same time.īefore copying files, delete all files with extension. Follow the instructions on the update guide. If updating from CL V1.61 or older, or if the message "NAME SUB CPU is old" appears after updating to V5.01, copy "CL-MD101.BIN" file in CL*_firm501/NAME SUB (* is the model number) to the root directory of the USB flash drive.This method allows you to update both the firmware and the "CL_SUBP_V500.BIN" and "MCLP5_01.PGM" files together at the same time. You can now update the Dante firmware for CL also by using the USB flash drive. You also need to update the Dante firmware. If updating from CL V4.51 or older, copy files "CL_SUBP_V500.BIN" and "MCLP5_00.PGM" to the root directory of the USB flash drive.You don’t need to update the Dante firmware.
0 kommentar(er)
